PCT-102 Push Wire Connector 2 Port Inline Terminal Block 250V

The PCT-102 is a 2-port push wire connector rated up to 250V, used to join or extend copper conductors inline.

It works with a push-in spring clamp: strip the conductor, push it into the port, and the clamp holds it — no screwdriver, no crimping tool. Each connector has two independent ports, so it joins one conductor to another rather than distributing to multiple branches.

Where it fits

This suits mid-run joins inside a junction box, camera back box, or electrical enclosure — points where a CCTV power feed, alarm cable, or lighting/control circuit needs extending without a full termination panel. The housing is transparent, so you can see the conductor is fully inserted before closing the enclosure.

Conductors

It accepts solid and stranded copper conductors, covering the cable types found in CCTV power runs and low-voltage control wiring, as well as mains-rated circuits within its 250V limit.

Key specs

• Ports: 2 independent push-wire terminations
• Voltage rating: up to 250V
• Conductors: solid and stranded copper
• Termination: push-in spring clamp, tool-free
• Housing: transparent insulated body

Check the enclosure has room for the connector plus cable bend before specifying it for a confined junction box.